Dollar Bill $

Model Created and Diagrammed by A. Anselmo 12/93

(although I’m certain someone has done something like it.)

anselmo@thermsa.eng.sunysb.edu

3) Fold along 4) Unfold the 5) Keep the right

1) Fold the bill 2) Fold edges the indicated left side. The object hand side together, lengthwise, and towards the lines. of the next few folds and fit the pocket unfold. Fold edges middle again. is to create a locking forming at "A" into in to the middle. mechanism. the shaded tab.

A valley 8) Lay the fold sideways, and make it into a reversed

"S" shape with a series of valley and mountain folds.

Of course, when looking at it unfolded, all the folds

valley

mountain appear as valley folds. The reverse "S" here is shown

a bit more "open" than I usually make it. The tighter

valley the "S", the more of a tail you will be left with to make

mountain the vertical line that goes through the "S". Take note!

6) How the fold 11) This. 7) This should

progresses. Valley fold be locked by

now. upwards at the

indicated point.

I 10) Mountain fold

only the top flap to 12) Valley fold

O the left to achieve... and mountain

fold so this last

piece can collapse

I

towards you.

9) Unfold the last

16) Valley

valley fold. Make

the folds "I" inside 14) Now you under the middle fold upwards, reverse folds, and "O" should have and over the top. outside reverse folds,

this. Fold this

so the reverse "S" shape long flap to the will not come apart.

left.

17) You should

have this now.

Flip it over, and

15) Valley you have a

13) You should fold the flap "Dollar $" ! only follow the so it hangs indicated folds downwards. to collapse this Note: This model appears best

after sitting in your wallet for a few hours,

section.

since the creases have time to set.