Before starting assembly:Writing the number of each section on its

back side before cutting out the sections is highly recommended. Indicates where sections should

(* This way, you can be sure which section is which even after cutting out be glued together.

http://www.canon.com/c-park/en/ the sections.)

6 7

View of completed model 7

*This model was designed for Papercraft and may differ from the original in some respects.

Assembly Instructions:Five A4 sheets(No.1 to No.5) 3 Parts 1 - 7

*Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.

*Hint: Trace along the folds with a ruler

and an exhausted pen (no ink) to get a sharper, easier fold.

Assembly Instructions Parts 1 + 2 + 3 + 6

Glue

Mountain fold(dotted line)

Make a mountain fold. The glue spot(colored dot)

shows where to apply the glue.

Valley fold(dashed and dotted line) Glue spot(Red dot)

Make a valley fold. Glue parts with the same number together. 9 These parts have Scissors line(solid line) the same width. Glue spot(Green dot) 10 Cut along the line. 10 Glue within the same part. 10 Cut in line(solid line)

Cut along the line. Glue to the rear of the other part. Glue spot(Blue dot)

Tools and materials ballpoint pen, toothpicks, tweezers, (useful for handling small parts) Scissors, set square, glue(We recommend stick glue), pencil, used

Before gluing, crease the paper along mountain fold and valley Parts 8 + 9

Assembly tip fold lines and make sure rounded sections are nice and stiff.

Parts 4 + 5 + 7 Glue parts 8 and 9 to this base.

Caution Glue, scissors and other tools may be dangerous to young children

so be sure to keep them out of the reach of young children.

Parts 1 - 10

12 12

12 Parts 1 - 13 Parts 1 - 13

Parts 14 - 18

11 19

14 Fold parts 19, 20, and 24 in two

and glue together. Cut these parts

after the glue has dried.

30 30 28

Parts 1 - 18

29 29 29

Parts 21 - 24

Fold parts 31 and 32 in two

and glue together. Parts 25 - 28 Cut these parts after the glue has dried.

Parts 1 - 24

Parts 1 - 32

Parts 25 - 32

35 Parts 40 + 41

Parts 1 - 32 33 Parts 40 and 41 are reinforcements. 41

Glue near the center of parts 33 - 36.

Parts 42 + 43

43 42

37 Parts 42 and 43 are reinforcements. Finished!

Glue near the center of the stand.